How to Program Single stage heating for Commercial Microwave Oven

Programming Memory Pads for Single Stage Heating

1. DO NOT OPEN THE DOOR
   The Display Window must be blank before programming can begin. If any indicator light is illuminated in the digital Display Window, close the door, press the STOP/RESET pad, and wait 1 minute until the Display Window goes blank.
   • Note: “Program Lock” should be cancelled (see page 14).
     Example: Program 30 seconds at Medium Power for Memory Pad #5.
     1. Press the PROG. pad.
        • If no PROG indicator appears in the Display Window, “Program Lock” should be cancelled (see page 14).
        • Do not press and hold the PROG. pad for more than 30 seconds, or a false failure code may result.
     2. Press Memory Pad 5.
        • The pad number and the previously selected time and power level will appear in the Display Window.
        • The pad number and Stage Heating indicator will appear in the Display Window again.
     3. Press the POWER Level Selector pad 3 times (Medium Power). The Memory Pad display will go out.
     4. Press Memory Pads 3 and 0 to set 30 seconds.
     5. Press the PROG. pad again to save.
        • Programming is complete for single stage heating and automatic double heating time for multiple portion heating.
        • After 2 seconds, the single stage time and power level will appear.
        • After 2 seconds, the Double Quantity (x2) indicator and double heating time will appear.
        • After 2 seconds, the Display Window will go blank.

1. Programming Notes
   • Program the remaining Memory Pads as desired by repeating steps 1 to 5. You may store up to 10 memory programs.
   • When the PROG indicator is blinking, the program can be cancelled and/or the pad erased by pressing the STOP/RESET pad.

   This answer applies to the following models; NE-1054, NE-1064 however it may apply to others. For specific model information refer to the operating instructions