Home
>
Commercial Microwave Oven Programming Memory Pads for 2 or 3 Stage Heating (NE-1054/1064 models)

Commercial Microwave Oven Programming Memory Pads for 2 or 3 Stage Heating (NE-1054/1064 models)

Note:

  • Program the remaining Memory Pads as desired by repeating steps 1 to 5. You may insert up to 10 memory Programs.
  • When the PROG indicator is blinking, the program can be cancelled and/or the Pad erased by pressing the STOP/RESET Pad.

Programming Memory Pads for 2 or 3 Stage Heating


Example: Program 2 minutes at DEFROST for 2-stage heating using Memory Pad #5.

  1. Complete Steps 1 to 4 from page 11.
  2. Press the POWER Level Selector pad 5 times. The DEF indicator light will illuminate.
  3. Press Memory Pads 2, 0, and 0 to set 2:00.
  4. Press the PROG. pad again to save.
    • Programming is complete for 2-stage heating and automatic double heating time for multiple portion heating.
    • After 2 seconds, the Display Window will show the programmed settings.
    • The time for multiple portion heating will be displayed.
    • After all programming is completed, the Display Window will go blank.
  • Important Notes
    • DO NOT OPEN THE OVEN DOOR during programming.
    • To program additional pads, repeat the steps above.
    • For a 3-stage heating cycle, select an additional power level and set the desired heating time between steps 3 and 4.

    • This answer applies to the following models; NE-1054, NE-1064 however it may apply to others. For specific model information refer to the operating instructions