How do I adjust the Armlift height on the Turntable

Some Technics turntables allow you to adjust the tonearm/armlift height. If needed, make this adjustment to match your cartridge’s height so the stylus cues safely and clears the record properly. Refer to the drop-down list below for model-specific guidance. If your model isn’t listed, consult your model’s operating instructions before attempting any adjustment to prevent physical damage.

Drop down slection option

Model SL-1200G

Make an adjustment according to your cartridge if necessary.

Preparation

Put a record on the turntable.
Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp.
Lift the cue lever and move the tone arm over the record.

Check the armlift height (distance between the stylus tip and record surface). If adjustment is needed, go to the step 2.
- The armlift height is factory-adjusted to 8 to 13 mm (5/16” to 33/64”).
Return the tone arm to the arm rest and fix it with the arm clamp.
Turn the adjustment screw.
- Turning the screw clockwise lowers the armlift.
- Turning the screw anti-clockwise raises the armlift.

Model SL-1200GAE

Model SL-1200GR

Model SL-1200GR2

Model SL-1210G

Model SL-1210GAE

Model SL-1210GR

Model SL-1210GR2

Model SL-40C

For this model the tonearm height/arm-lift height cannot be be adjusted. It recommends using an MM cartridge such as the Ortofon 2M Red (H = 18 mm). For cartridge replacement, purchase and use the ortofon 2M Red" (height (H): 18mm).