How to clean the facial cleansing device. - EH-XC10
- Rinse foam off the brush with water and then remove.
- Open the facial cleanser compartment cover, begin pouring
water into the foam dispenser, and then press the facial
cleanse switch to rinse.
- If a significant amount of facial cleanser remains, the
power may turn off a few seconds after pressing the facial
cleanse switch or it may not operate smoothly. In such
cases, use warm water to clean and remove the excess
cleanser.
- If a significant amount of facial cleanser remains, the
power may turn off a few seconds after pressing the facial
cleanse switch or it may not operate smoothly. In such
cases, use warm water to clean and remove the excess
cleanser.
- Press the facial cleanse switch to turn off the power.
- Manually clean the brushes, warming makeup removal plate,
and around the facial cleanser compartment.
- Clean the facial cleanser compartment thoroughly as facial
cleanser tends to accumulate in this area.
- If you become concerned about dirt accumulating in the brush, apply facial cleanser to the brush and wash it by hand.
- Please note that the bristle portion of the silicone brush may come off if pulled strongly.
- Please reattach the silicone part if it becomes detached.
- Shake the main body to remove excess water.
- Lightly wipe with a towel or similar and place on the stand
to dry.
- Leave the facial cleanser compartment cover open to dry.
- Place the brush and measuring cap at the rear of the stand.
- After cleaning, store in a location with low humidity. (Storing the appliance in an enclosed shower or bath may cause condensation and rust to develop inside the main body leading to failure.)