How to use the facial cleansing brush. - EH-XC10
- If you are still wearing makeup, first remove the makeup using the warm makeup removal mode or remove eye makeup with your hands.
- Attach the soft brush by pressing it until it clicks into
place.
- Open the facial cleanser compartment and add facial
cleanser. Add the recommended amount as indicated on your
facial cleanser product (the amount you normally use).
- Use a foaming facial cleanser.
- Depending on the type of facial cleanser (sticky facial cleansers, etc.) or the amount used, the facial cleanser may not mix properly and clog the appliance. In rare cases, power to the appliance may be interrupted.
- The quality of foam varies depending on the type of facial cleanser. Adjust to the recommended amount as indicated on your facial cleanser product.
- Do not add anything other than facial cleanser into this appliance. (Doing so may cause malfunction.)
- If you are using a non-foaming type facial cleanser, moisten the brush and your face with water and apply the facial cleanser directly onto your skin.
- Fill the measuring cap with water (approximately 4 mL) and
pour into the center of the brush.
- Press the facial cleanse switch and select a mode. Foam
starts to dispense approximately 5 seconds after turning on the
appliance.
- Pressing the facial cleanse switch cycles through the Power OFF, Normal, Soft options.
- The mode is always set to Normal when the power is turned on.
- Wash off any excess facial cleanser on your hands.
- Add more water if the amount of foam is insufficient.
- Wash your face.
- Do not apply the appliance to the same area for extended periods of time.
- Wash your face in 3 sections as illustrated in the following diagram for approximately 20 seconds per section.
- You can use this appliance on your neck and upper chest, but do not apply it to your throat.
- Recommended ambient temperature for operation is 5 – 35 °C (41 - 95 °F). The appliance might not be usable outside of the recommended temperature range. Notification timer feature notifies you of the recommended cleansing time by pulsing every 20 seconds.
- Do not press the bristles of the soft brush into your skin. Lightly apply the brush to your skin so that the bristles just touch the skin and then wash your face in a circular motion. If you feel irritation even if you are not pressing the brush into the skin, stop using the brush.
- Do not use the brush around your eyes.
- After you have finished washing your face, press the facial
cleanse switch to turn off the power.
- Make sure to wash the appliance after use.
- The power will be automatically turned off approximately 1 minute after the power is turned on.