How to use the [ Power Shot ] and [ Vertical Shot ] features.

  • The " Power Shot " feature provides extra steam which goes deep into the garment and is helpful for removing stubborn wrinkles.
  • The "Power Shot" feature operates properly only in the "HIGH" indication area of the "SET" Pad when steam or dry ironing (if used at a lower setting, water spotting will occur because the iron is not hot enough to change water to steam). 
  • If you have not used the " Power Shot " feature for a long time, it is necessary to clean the inside of the iron before using this feature on any clothes to be ironed.
  • Simply test the " Power Shot " feature several times away from the ironing board and clothes to be ironed. This will prevent brown spotting or water spotting on clothes.

  1. Fill the iron with water.
  2. Plug the Power Cord into the household outlet.
  3. Set the iron to the Power Base securely. The green "OFF" light will turn on.
  4. Push the "SET" Pad to the "HIGH" temperature level. The red light starts blinking.
  5. Set the Steam/dry selector to the dry position.

    null
  6. Preheat the iron until the ligh turns continuously, usually takes about 1- 2 minutes. Simply pump the "Power Shot Button" when steam is desired. Pump the "Power Shot Button" several times at the begining of each ironing session.

    power shot button
     
  7. Allow at least 5 seconds between uses of the [ Power Shot ] button to prevent water spotting. Use a press cloth if necessary.

Note:

Do not touch the fabric with the iron. Keep the iron slightly over the fabric to prevent burns or disfiguring.


Vertical Steam

null


Follow the above set up procedure.

  • To get better results when using vertical steam, hang the garment on a hanger.
  • Curtains and drapes may also be steamed once they are hung.
  • Hold the iron away from your body, close to but not touching the fabric. Pull the fabric tightly and pump the power shot button at 5 seconds intervals as you pass the iron over the wrinkled fabric.
  • If the power shot weakens, wait until the thermostat operating indicator light goes on, and then off.

Anti-Drip System (Automatic water Seal)


  • These model has an Anti-Drip System. When the temperature of the Soleplate's surface drops below 250°F(121°C), the valve for the vaporizing chamber in the iron automatically closes and stops the water from going in further. This prevents hot unvaporized water from ejecting out of the soleplate when the iron has cooled down. With this system, it is necessary for you to wait until the inside of the vaporizing chamber dries completely when you store the iron.
Note: It is not a sign of malfunction when you hear a clicking sound. This sound can be heard whenever this system is activated.


The following answer is for model; NI-WL600, NI-WL602, NI-WL607AP

©2024 Panasonic USA All rights reserved.

Our website uses cookies and similar tools to improve its performance and enhance your online user experience. By continuing to use this website without changing your settings, you consent to their use.