How to use the [ Power Shot ] and [ Vertical Shot ] features. - NI-U600C
- The " Power Shot " feature provides extra steam which goes deep into the garment and is helpful for removing stubborn wrinkles.
- If you have not used the " Power Shot " feature for a long time, it is necessary to clean the inside of the iron before using this feature on any clothes to be ironed.
- Simply test the " Power Shot " feature several times away from the ironing board and clothes to be ironed. This will prevent brown spotting or water spotting on clothes.
- Fill the iron with water.
- Set the Steam/dry selector to the dry position.
- Position the iron vertically and set the Temperature Selector is set to the [ MAX ] position.
- Preheat the iron until the Thermostat Operating Indicator light goes out, usually takes about 1- 2 minutes. This light will go on and off during ironing to indicate that the temperature chosen by the Temperature Selector is being maintained.
- Simple pump the [ Power Shot ] button when steam
is desired. Pump the [ Shot ] button several times at the
beginning of each ironing session.
- Allow at least 2 seconds between uses of the [ Power Shot ] button to prevent water spotting. Use a press cloth if necessary.
Vertical Shot
Follow the above set up procedure.
- To get better results when using vertical steam, hang the garment on a hanger.
- Curtains and drapes may also be steamed once they are hung.
- Hold the iron away from your body, close to but not touching the fabric. Pull the fabric tightly and pump the power shot button at 2 seconds intervals as you press the iron over the wrinkled fabric.
- If the power shot weakens, wait until the thermostat operating indicator light goes on, and then off.