How to use the [ Power Shot ] feature.
- The " Power Shot " feature provides extra steam which goes deep into the garment and is helpful for removing stubborn wrinkles.
- The " Power Shot " feature operates properly only in the [ ] position of the Temperature Selector when steam or dry ironing (If used at lower setting, water spotting will occur because the iron is not hot enough to change water to steam).
- If you have not used the " Power Shot " feature for a long time, it is necessary to clean the inside of the iron before using this feature on any clothes to be ironed.
- Simply test the " Power Shot " feature several times away from the ironing board and clothes to be ironed. This will prevent brown spotting or water spotting on clothes.
- Fill the iron with water (refer to How to fill water).
- Position the iron vertically and be sure the Temperature Selector is set to [ Off ].
- Plug the main lead into the household socket.
- Set the Temperature Selector to the [ ] position.
- Preheat the iron until the Thermostat Operating Indicator light goes out, usually takes about 1- 2 minutes. This light will go on and off during ironing to indicate that the temperature chosen by the Temperature Selector is being maintained.
- Simple pump the [ Shot ] or [ Power Shot ] button
when steam is desired. Pump the [ Shot ] or [ Power Shot ]
button several times at the beginning of each ironing
session.
Image varies by model - Allow at least 2 seconds between uses of the [ Shot ] button to prevent water spotting. Use a press cloth if necessary.
This answer is for the following models; NI-E660S, NI-E665S, NI-M300T.